Why is the washing machine Ariston not pressing the laundry?
If you are the owner of a washing machine brand Ariston or Hotpoint-Ariston and after the next wash cycle, you noticed that she stopped pressing underwear - this article is for you. In it, we consider the main reasons why the Ariston washing machine does not squeeze.
Let's say right away - not always the absence of spin is a breakdown of the unit. You can find wet things at the end of the cycle if:
- The drain hose is pegged or twisted and water cannot enter the sewer system. Check that the diverting communications are in order.
- You have chosen the spin-free mode of washing - for example, for delicate or woolen items. In this case, if you still need to spin, we recommend running it separately.
- You have chosen a program with low spin speeds, or you have turned on the lower speed itself. In this case, there will be no water in the tank, but at 600-800 revolutions the laundry will remain quite wet. Run the spin cycle again, setting the revolutions higher.
- Perhaps there are too many cars in the tank or, on the contrary, not enough laundry.Some models of modern styrales Ariston and Hotpoint-Ariston are equipped with a weight sensor in the drum. Such models may not start spinning if they “believe” that the weight of the laundry does not correspond to the optimal one.
Try to remove some of the things from the drum (or vice versa - report back) and start the spin cycle again. In case you have checked all the settings of the washing machine and they are in order, but your Ariston still does not squeeze out the laundry or does not do it very well, probably there was a breakdown in the unit.
Failures of washing machines Ariston, in which the spinning does not work correctly
A lack of spinning or low spinning underwear can cause a number of faults. The most frequent of them are:
Breakdown of the drain pump
In this case, the outflow of water into the sewage system is difficult and the machine does not start spinning. As a result, the laundry remains moist. To fix the problem requires the replacement of the pump.
On machines equipped with an electronic scoreboard, error code F05 or F11 may be displayed. For more information on what the codes of Ariston washing machines mean, you can find out on the site of the RemBitTech workshop by clicking on the link.
Pressure switch malfunction
The failure or incorrect operation of the water level sensor may also cause the machine not to squeeze the laundry. With such a breakdown, the error code F05 or F10 appears on the display.
Water level sensor to be replaced.
Tacho Sensor Fault
In the event of a breakdown or malfunction of the rev level sensor, the machine cannot accelerate to the required speed, as a result, the spinning does not occur or does not occur well. In case of breakdowns of the tahodatchka, the electronic washers Ariston give an error F02. A failed sensor must be replaced.
Also, the F02 error in Ariston may indicate engine malfunctions, which also prevent the unit from squeezing the laundry properly. Often, the reason lies in the erased graphite brushes: due to the lack of sufficient voltage, the washer can not disperse the drum to the desired speed, as a result - the laundry remains wet. To solve this problem, the master changes the erased brushes.
In case the problem is detected in the engine (for example, in case of breaks in the winding), the motor is completely replaced.
Failures in the control module
In Ariston electronic washers, this failure may be accompanied by an F18 error code. The symptomatology at the same time is very diverse - in the machine it may not work to spin or fail any other program. A flashing or replacement of a failed node is required.
As you can see, a variety of problems in the unit can lead to problems with the spin cycle. Therefore, if you are faced with the difficulties of spinning, it is better to immediately contact professional specialists in repairing household appliances. They will find and eliminate the cause and your washing machine Ariston will serve you more than one year!